Guide
PFAS in drinking water: the limits and the dates
In April 2024 EPA set the first national limits for six PFAS in drinking water. Water systems must meet them from 2029. In May 2026 EPA proposed to keep the two main limits and drop the rest; as of November 11, 2026 that proposal is not final.
What are EPA's PFAS limits for drinking water?
The April 2024 rule sets enforceable maximum contaminant levels (MCLs) for five PFAS and one for mixtures. A part per trillion (ppt) is the same as a nanogram per liter (ng/L).
| PFAS | Limit (MCL) | Health goal (MCLG) |
|---|---|---|
| PFOA | 4.0 ppt | Zero |
| PFOS | 4.0 ppt | Zero |
| PFHxS | 10 ppt | 10 ppt |
| PFNA | 10 ppt | 10 ppt |
| HFPO-DA (GenX chemicals) | 10 ppt | 10 ppt |
| Mixtures of two or more of PFHxS, PFNA, HFPO-DA and PFBS | Hazard Index 1 | Hazard Index 1 |
The hazard index is a limit for the mixture as a whole. It can only be violated when at least two of those four PFAS are present at measurable levels, and PFBS has no limit of its own. The goal (MCLG) is a health target, not an enforceable limit. The rule applies to community water systems and to non-transient non-community systems, which regularly serve at least 25 of the same people over six months a year.
Source: Per- and Polyfluoroalkyl Substances (PFAS) (EPA); PFAS Compliance Determination: A Quick Reference Guide (EPA, January 2025); 40 CFR 141.2, definitions (eCFR), read November 11, 2026.
When do water systems have to meet the limits?
By April 26, 2029. The rule was published on April 26, 2024. Systems had three years, to April 26, 2027, to finish initial monitoring, and must report their PFAS levels to the public from 2027. From April 26, 2029, a system over a limit must reduce PFAS and notify the public of the violation.
Compliance is judged on a running annual average: the average of the samples from the previous four quarters at each point where treated water enters the system. If any one entry point's average is over a limit, the system is in violation. Usually a system is not in violation until it has a full year of quarterly results. The exception is a result so high that the average must exceed the limit whatever the later samples show, for example one sample more than four times the limit. Then the system is out of compliance at once.
Source: PFAS Compliance Determination: A Quick Reference Guide (EPA, January 2025); Per- and Polyfluoroalkyl Substances (PFAS) (EPA), read November 11, 2026.
What did EPA propose to change in May 2026?
On May 18, 2026 EPA announced two proposals:
- Keep PFOA and PFOS at 4.0 ppt, with more time. Systems could request a two-year exemption, moving their deadline from April 2029 to 2031. A system granted one would have to tell the people it serves.
- Withdraw the other limits. EPA would rescind the limits for PFHxS, PFNA and HFPO-DA and the hazard index for mixtures of those three and PFBS.
EPA held a virtual public hearing on July 7, 2026, and the comment periods for both proposals closed on July 20, 2026. As of November 11, 2026, EPA's pages for both still describe them as proposed rules. Until a final rule is published, the April 2024 rule stands as written, with all six limits.
Source: Proposed PFOA and PFOS Compliance Extension Rule (EPA); Proposed PFAS Rescission Rule (EPA); Per- and Polyfluoroalkyl Substances (PFAS) (EPA), read November 11, 2026.
What did UCMR 5 measure?
UCMR 5 was a national round of testing for 29 PFAS and lithium, carried out under EPA's Unregulated Contaminant Monitoring Rule. Systems sampled during a 12-month period between January 2023 and December 2025. It covered every community and non-transient non-community system serving 3,300 people or more, plus a representative sample of 800 smaller systems.
EPA released the final UCMR 5 data set in August 2026, with a data summary dated July 2026. In that summary EPA estimates that 7.8 percent of public water systems nationwide had at least one average above a 2024 PFAS limit, weighting the results so small systems are fairly represented.
Source: Fifth Unregulated Contaminant Monitoring Rule (EPA); UCMR 5 Data Summary, July 2026 (EPA 815-S-26-007), read November 11, 2026.
Is a UCMR 5 result above 4.0 ppt a violation?
No. EPA states that UCMR 5 results for the regulated PFAS do not show compliance or noncompliance with the limits. Compliance will be decided from the system's own compliance monitoring, as a running annual average of quarterly results reported to the state, from 2029.
A single UCMR 5 result is one sample on one day. It tells you PFAS was found at that level at that sampling point. It does not tell you the yearly average, today's level, or whether the system has added treatment since.
Source: UCMR 5 Data Summary, July 2026 (EPA 815-S-26-007), read November 11, 2026.
How do I read PFAS results on PlainEnviro?
Start at PFAS results by state, or open your water system from find by ZIP or search. A system page lists each substance it tested for under UCMR 5 with its highest result, the reporting level, the 2024 limit and how many samples found it. "Above 2024 limit" there means the highest single result was over the limit. It is not a compliance finding, for the reasons above. The national picture is in PFAS in drinking water: the final UCMR 5 results, and every federal limit is on drinking-water limits.
For your own water, ask your utility for its latest results and its annual water quality report. For what a level means for your health, ask your doctor.