EPA TRI Facility · Fabricated Metals
Quality Fab Inc.
Ariton, AL
- Total releases
- 703 lbs
- Chemicals reported
- 5
- Carcinogens
- 2
- Primary pathway
- Air Releases
Reported-total composition
How the reported total is distributed
703 lbs across all reported pathways
- Air Releases 703 lbs 100.0%
The segments reconcile to the cumulative total shown above. Off-site transfers are shown separately from releases to air, water, and land.
TRACE volume AIR pathway CARC-LEAN
Quality Fab Inc. is an EPA Toxics Release Inventory reporter in Ariton, AL, in the fabricated metals sector. It reported 703 lbs of releases across 5 chemicals in 2023. That ranks 14,355 of 25,986 TRI facilities nationwide by cumulative reported pounds, counting each facility over however many years it has filed. In Alabama's 559 reporting TRI sites, Chemical Waste Management leads both reported pounds (95.6M lbs) and chemical count (98 chemicals). The two rankings do not invert in this pool. Pounds reported are not a measure of toxicity or health risk. Nearest other TRI reporters: Arichem LLC; Brundidge Electronics Corp; Wayne-Sanderson Farms LLC - Enterprise Fresh Plant; Southeast Wood. Similar-scale Fabricated Metals peers outside Alabama: Tapcoenpro; The Ames Cos Inc; Valley Plating Works Inc; Dci Inc. Largest disclosed chemicals by pounds: Chromium; Manganese; Nickel; Copper.
Quality Fab Inc. has reported 703 lbs of toxic releases across 5 chemicals to the EPA Toxic Release Inventory, based on annual facility disclosures from 2019 through 2023. Of the chemicals reported, 2 are classified as carcinogens, representing 40% of the facility's chemical profile. The facility operates in the Fabricated Metals sector. The primary release pathway is air releases, accounting for 100% of total releases. All release data shown below is self-reported to the EPA under the Emergency Planning and Community Right-to-Know Act (EPCRA) Section 313.
Quality Fab Inc. vs. every reporting TRI facility
Cumulative reported release pounds, with this facility marked in the national distribution
703 lbs 45th percentile higher than 45% of 25,986 reporting TRI facilities
Each bar is a $1M-wide band; taller bars hold more reporting TRI facilities. The dashed line and filled bar mark this facility. Hover, focus, or tap a bar for its full count, share, and position.
Source U.S. Environmental Protection Agency, Toxics Release Inventory · 2023 reporting year
Where this facility sits in the TRI record
Among the 3,421 Fabricated Metals facilities in this database, Quality Fab Inc. reports the 1,821st-largest volume (703 lbs).
Placement is computed from reported TRI pounds in this database. Thresholds are fixed across every facility page: concentrated ≥60% of volume in one chemical, county-dominant ≥25% of the county total, carcinogen-heavy ≥50% of pounds. Share-based statements are shown only for sites reporting at least 1,000 lbs, because a share of a very small total is not a meaningful signal. Reported pounds are self-reported estimates and do not measure toxicity or health risk.
Quick Facts
Compare this facility
See how Quality Fab Inc. stacks up against nearby facilities and the typical reporter.
99% less than the comparison
About the same as the comparison
Comparison reflects reported pounds and chemical counts, not toxicity or health risk. Averages cover facilities reporting any release.
How does this facility release toxic chemicals?
How Quality Fab Inc. releases toxic chemicals into the environment. Total: 703 lbs.
Location
Nearest TRI Facilities to Quality Fab Inc.
Closest other reporters in Alabama - including Arichem LLC, Brundidge Electronics Corp, Wayne-Sanderson Farms LLC - Enterprise Fresh Plant, ordered by distance.
Showing 8 of 558 other reporting facilities in Alabama.
Similar Fabricated Metals Facilities
Other Fabricated Metals facilities with similar total release volumes (±80%), outside Alabama - e.g. Tapcoenpro, The Ames Cos Inc, Valley Plating Works Inc.
About TRI Data
Data as of 2023 reporting year. Source: U.S. Environmental Protection Agency (EPA) Toxic Release Inventory.
On this page the largest disclosed chemicals include Chromium, Manganese, Nickel, Copper; nearby reporters include Arichem LLC. Quality Fab Inc. stamps TRACE volume · AIR pathway · CARC-LEAN carcinogen-lbs on this Form-R extract. Totals are self-reported estimates under EPCRA §313, not measured stack emissions or a health-risk score.
Use and verify this record
This Quality Fab Inc. record combines EPA TRI filings, facility identity, and compliance context without turning reported releases into a health-risk rating.
TRI release totals are self-reported estimates, not measured stack emissions. The methodology explains how records are joined, computed, and refreshed.
PlainEnviro renders public EPA records directly from its data pipeline; no figure on this page is typed in by an editor. See the editorial standards and corrections policy for how source changes and reported errors are handled.
All federal data sources used on this page
- EPA Toxics Release Inventory (TRI) Basic Data Files - annual self-reported chemical-release filings. epa.gov
- EPA TRI Program reference - how chemicals and reported releases are counted. epa.gov
- EPA Facility Registry Service - facility location and identity. epa.gov
- EPA ECHO - regulatory and compliance context. epa.gov
- EPA Envirofacts - the EPA data warehouse exposing these datasets. epa.gov